Sticker (cutting type) kids on board painted by HIMARI * 01

This design is a picture of a girl. I worked hard while thinking about my family. The girl's face when the sticker is finished is too loving. . I was not happy. (Size) Length 10 cm × Width 20 cm ※ We produce sticker using cutting sheet (white, black). The sticker has a 3-sheet structure of 1, transfer sheet, 2, cutting sticker, 3 and release paper. (How to paste stickers) ○ What to prepare Squeegee (Squeegee is like a spatula, but you can substitute a towel on a ruler.) Masking tape Where to put, please wipe off dirt such as oil and dirt and dust. Please keep in mind that if there is any waste left it will lead to peeling off etc. 1 Firmly press and crimp the cutting sticker and transfer sheet. If you do not press firmly, the cutting sticker will easily remain on the backing (release paper) side. Please be careful not to break the transfer sheet. If the transfer sheet breaks, reinforce it with masking tape. 2 Firmly press-fit from the reverse side (release paper side). Crimping from the back also makes it easy to stick small letters firmly to the transfer sheet. (3) After completion of crimping, peel off the end a little and check if it is properly stuck on the transfer sheet. (4) Decide the position to paste and temporarily fix the lower side with tape. Turn over the lower tape around the axis. 5 Turn over the cutting sticker, taking care not to remove the fixing tape on the lower side. Remove the sheet from the release paper and stick it to the transfer sheet. Be careful as it may break if you peel it vigorously. Slowly remove it while checking that the sticker is stuck on the transfer sheet. (6) Please apply pressure while slowly pressing with a squeegee, taking care not to squeeze the sheet. Please be careful not to get wrinkled. Take care not to apply excessive pressure, as the transfer sheet may be torn. 7) Crimp the air radially from the center with a squeegee so that the air between the construction surface and the cutting sticker completely escapes. At this time, it is easy to be wrinkled if you put in force at a stretch, so if you can slide lightly and crimp it entirely without wrinkles, please put a little force again on the finish and crimp it firmly. 8Peel off the transfer sheet and the masking tape if you can press firmly. If you remove it vigorously, there is a risk that the part that is not stuck well on the construction surface may be cut off, so please be sure to remove it slowly while making sure that it is firmly attached. ※ If air gets in, even if air bubbles are generated in the sheet, please do not remove it forcibly. The cutting sticker is so thin that if you pull it by force, it will stretch or break immediately and will not be corrected. Squeeze the air out of the center of the sticker. 9 is completed. ★ returns and exchanges are not done. Thank you for your understanding. If you have any questions, please contact us anytime.